JoeJ wrote:Why don't you post your factory file. It's hard to guess just based on your picture of the STL.
Sorry I fixed the image. I linked the wrong picture and couldn't fix it while waiting for the thread to be approved.
Search found 3 matches
- Sat Nov 07, 2015 10:35 am
- Forum: Troubleshooting and Bug Reports
- Topic: 100% infill not actually 100%
- Replies: 3
- Views: 2547
- Jump to post
Re: 100% infill not actually 100%
Sorry I fixed the image. I linked the wrong picture and couldn't fix it while waiting for the thread to be approved.
- Fri Nov 06, 2015 10:51 am
- Forum: Troubleshooting and Bug Reports
- Topic: 100% infill not actually 100%
- Replies: 3
- Views: 2547
- Jump to post
100% infill not actually 100%
Sorry if this has been brought up in the past but I couldn't find it in a search. From what I recall when I was using slic3r and S3D 2.x when I set infill to 100%, every layer had truly 100% coverage. Since upgrading to S3D 3.x my "100%" infill prints aren't truly 100%. Here is an example:...
- Sat Jan 17, 2015 4:15 pm
- Forum: Troubleshooting and Bug Reports
- Topic: TAZ 4 Issue
- Replies: 7
- Views: 6625
- Jump to post
Re: TAZ 4 Issue
Same issue here. Just got a TAZ and all of my prints using slic3r went fine. But when I try to use S3D it just hangs at bed heating. I notice in the communication log it shows the bed temp as 89.6, while the LCD on the TAZ says 90. I'm assuming the TAZ rounds up for the LCD. My workaround has been t...
