Thanks for the response
The feature suggests hole compensation separate from the part, cannot see anything for the life of me that will do that other than a `general` inner compensation which is really not the same?
Thanks
Boothy
Search found 6 matches
- Wed Dec 21, 2022 10:51 am
- Forum: General Discussion and Tips
- Topic: How do you operate Individual Hole Compensation?
- Replies: 3
- Views: 3052
- Jump to post
- Wed Dec 21, 2022 10:15 am
- Forum: General Discussion and Tips
- Topic: VORON 2.4 PROFILE
- Replies: 3
- Views: 2767
- Jump to post
Re: VORON 2.4 PROFILE
I think suggesting that because there is a lot of variation you should therefore sit on your our hand and not make effort to include Voron profiles is just utter rubbish. No wonder you have such a poor reputation within the community. Pull your finger out and make your product worthwhile and relevan...
- Wed Dec 21, 2022 9:45 am
- Forum: General Discussion and Tips
- Topic: How do you operate Individual Hole Compensation?
- Replies: 3
- Views: 3052
- Jump to post
How do you operate Individual Hole Compensation?
Title says it basically, how do you operate Individual Hole Compensation?
Also is there an operational guide to the new features, I have seen all the spin, just want to know how these things are implemented.?
Thanks in advance
Boothy
Also is there an operational guide to the new features, I have seen all the spin, just want to know how these things are implemented.?
Thanks in advance
Boothy
- Wed May 27, 2020 7:29 am
- Forum: Feature Requests
- Topic: Extra perimeters for specific walls
- Replies: 11
- Views: 13123
- Jump to post
Re: Extra perimeters for specific walls
This would also be very useful for single wall printing with large nozzles. I like to use large nozzles with higher layer heights for fast printing but with single perimeters you can get some dragging of the filament at the start of the loop which appears like under extruding at the start of the Z s...
- Wed May 27, 2020 7:10 am
- Forum: Feature Requests
- Topic: Automatic reduction of layer height to top number of layers
- Replies: 1
- Views: 1095
- Jump to post
Automatic reduction of layer height to top number of layers
I am not sure if this is gcode possible. I enjoy using large nozzles with large layer heights for fast large printing. If coding possible it would be really useful for several top layers to automatically reduce layer height to provide a better top finish. Clearly you can reduce via creating a new pr...
- Wed May 27, 2020 7:02 am
- Forum: Feature Requests
- Topic: Dual Wall\Perimeter start for large nozzle single walls
- Replies: 1
- Views: 908
- Jump to post
Dual Wall\Perimeter start for large nozzle single walls
When using a single perimeter for speed with a large nozzle the Z seam can often appear under extruded due to the large amount of filament being dragged from the start point irrelevant to the amount of retraction (does not occur with 2 perimeters). Therefore it would be really useful to have the opt...
