Thanks! On the FF forum, they recommended that I take off the "printed" spool holder I made for the eSUN reels/spools (they don't fit on the stock FFCP holders) and put back on the OEM holder and try the stock ABS that came with the unit.
They think it's the slop in the causing extruder issues... so I'm printing again right now to see what happens. One thing to note and I can't remember, I let it load for like a min and measured the extruded filament. I'm reading .64
Not .40 or anywhere close, is this right? Maybe this is the reason I'm over extruding?
P.S. OHH!! I edited my SailFish parameters so now the "jerk" is gone
it prints smooth but the lines are still there hence the spool change.
2012 10kw Dual LQ cooled Brusa powered Leaf "Astro"
10kw Enphase System,SolarWorld Panels, QuickMountPV- ALL USA!! + 3kw SW panels string tie.
I fly drones and R/C.
2014 Rav4 "SuperRav" JdeMO - 2015 Tesla 70d (Model 3 on deposit)