Simplify3D User Forum

Mayk

I can´t use my V4 anymore. It shows that I already have the maximum License used but when I try to deactivate one but there is only the V5 I can deactivate.

Regards

Mayk

Mayk

@ InspGadgt What file exactly did you try? Wing L1? I will try the same one here just to be sure it´s a general problem from S3D or maybe settings or whatever. I use S3D 90% for printing Airplanes and if it doesn´t work I don´t need it.

Mayk

Tried a Wing from B25, Q-Trainer and P38. B25 and Q-Trainer looking OK but the P38 not. There is missing some structure under the red marked part.

Mayk

This is a Sample from my Edge. Open as Factory file and directly sliced without changing parameters.

Mayk

@ InspGadgt What Model is this? I have a lot 3dLabprint Models. Tried the B25 and it´s working, If you tell me what part makes the problems I can test it here.

Regards#

Mayk

Mayk

For me deleting the file savedState, restart S3d and close the assistant on startup was working.

Mayk

Open Windows Explorer and navigate to the following directory: C:/Users/%USERNAME%/AppData/Local/Simplify3D/S3D-Software You may need to enable hidden folders to access this directory. Once there, please try deleting the file called "savedState.factory". Then, open Simplify3D again. worked...

Mayk

The Program starts but after a few seconds it crash with a error Message that something happens with the RAM Adress.+

Windows 10 all Updates installed. V4.1.2 is working.

Search found 8 matches

V4 License

Re: Simplify3D V5 no longer useable for RC airplane prints

Re: Simplify3D V5 no longer useable for RC airplane prints

Re: Does V5 still allow for thin-wall 3D printed wings / airplane slicing?

Re: Simplify3D V5 no longer useable for RC airplane prints

Re: Simplify3D will not start

Re: V5 Crash

V5 Crash